Go Back   2023 2024 MBA > MBA > Main Forum

  #1  
Old 17th November 2016, 07:05 PM
Unregistered
Guest
 
Default HAL MT Electrical Previous Papers

Can you provide me previous year Electrical question paper of Hindustan Aeronautics Limited or HAL for MT (Management Trainee) Post?
Reply With Quote Quick reply to this message
  #2  
Old 18th November 2016, 08:33 AM
Super Moderator
 
Join Date: Mar 2013
Default Re: HAL MT Electrical Previous Papers

The previous year Electrical question paper of Hindustan Aeronautics Limited or HAL for MT (Management Trainee) Post is as follows:


1) What is the distance between the EHV lines?
a)8m b)11m c)4m d)14m

2) At present how many HVDC lines are there in india?
a)none b)one c)two d)more than two

3) Where is the nuclear located in following places?
ans: i dont remember the answers, but one of them is thalcher(orissa)

4) What is the approximate peak overshoot for a unity feedback system with damping
factor 0.6?
a)10% b)5% c)15% d)20%

5) What is the distance between the EHV lines and earth?
a)8m b)11m c)18m d)15m

6) On no load in EHV lines what is the relation between receinving and sending end
voltage?
ans: receiving end voltage > sending end voltage

7) What is the surge impedance loading of 400kv line?
ans: 4002/400ohms =400watts

8) similar question with surge impedance given as 160 ohms
ans: 1000watts

9) If both the juctions of transistor are forward biased, in wat region transistor works
ans: saturation region

10) Where is the hydel power plant located in following places?
ans: I dont remember the places

11) self GMD is used in the calculation of_______
a) inductance only
b) inductance and capacitance
c) capacitance only
d) none

12) What is the GMD if the distance between the lines are 6m,6m,12m?
ans: 7.058m( approx)

13) Zero sequence currents doesn’t exist in the following fault
a) L-G
b) L-L
c) L-L-G
d) L-L-L-G
Ans: d

14) To avoid arcing connect sutable value of ________ in earthing.
a) capacitance
b) indunctance
c) resistance
d) susceptance

15)There are two to three questions based on Laplace and Inverse Laplace transforms

16)In the following type of conductors the corona is minimum
a) circular
b) stranded
c) helical
d) rectamgular
ans: c

17)When do two wattmeters show same value of opposite readings in two wattmeter
method
a) 300 lag
b) 600 lag
c) between 600 and 900 lag
d) zpf lag
ans: d

18) Schering bridge is used to measure
a) frequency
b) inductance
c) capacitance
d) mutual inductance
and: c

19) What is the value of resistance when both length and diameter of the wire are
doubled?
ans: halved

20) There is one questions asked on euler’s formula..

21) What is the Laplace transform of unit ramp signal?
ans:1/s2

22) What happens to the value of inductance when self GMD is doubled?

23) At what frequency corona loss is more?
a) 50Hz
b) 60Hz
c)
d)

24) What is the largest rating of alternator manufactured in india?
a) 1000MW
b) 500MW
c) 1200MW
d) 250MW
ans:b

25) The response of an RLC circuit for impuse input?
a) exponentially raising
b) sinusoidal
c) exponential falling
d) parabolic
ans: c

26) What is the easier method for finding no. of poles in the right half of s-plane?
a) Niquist plot
b) R-H criterion
c) Root-Locus method
d) Polor plot
ans: b

27) How many no of poles located in the right half of s-plane for the characteristic
equation…

28) Burden of current transformers is measured in..
a) Watts
b) Volt Amperes
c) Ampere Hours
d) Joules

29)What is the gate used to get high output when all the inputs are low?
a) NOR
b) NAND
c) Ex-OR
d) Ex-NOR
ans: b

30) Large no of thyristors are used in HVDC transmission to improve______
a) current rating
b) voltage rating
c) Thyristers are available at high ratings
d)

31) What is the line current of a circuit when the current transformer of 1000:5 rating
measures 4Amperes?
ans: 800A

32) If the time delay of relay with TMS setting 0.1 is 10 sec, then what is the time delaty
when the TMS setting is changed to 0.5

33) How many no of flip-flops are required to get 16 bit counter?

34) _________is connected to reduce frequency errors in ammeter.
a) shunt capacitor
b) series inductance
c) shunt inductance
d)

35)What is the value of ripple factor in Half Wave Rectifier?
a) 1.11
b) 0.8
c) 1.21
d)

36)The principle used in megger?
a) electrostatic effect
b) magnetic effect
c) Induction effect
d)

37)In electrodynamometer type wattmeter the error is due to..
a) pressure coil inductance
b) pressure coil resistance
38) In the following locations where is hydal power plant is not located?
ans: i dont remember the places

39) In distribution lines_____
a) X/R10
c) X/R>1
d) X/R<0.01

40) In EHV lines _____ a) X/R=10 b) X/R=100 c) d)

41) What is the speed of 2 pole alternator at 50Hz frequency? ans: 3000rpm

42) What is the equivalent decimal no of (624)8

43) What is the binary equivalent of 6.25

44) What is the value of A+AB+B¯ ( B bar) ans: 1

45) What are the avg and rms values of full wave rectifier ans: 2Vm/pie, Vm/21/2

46) There is one question based on rank of matrix

47) What is the equivalent of cos(wt+18.750) a) sin(wt+71.250) b) sin(wt-71.250) c) sin(wt+18.250) d) sin(wt-18.250)

48) The three harmonics will be in phace with each other?_____ a) 3,5,15 b) 2,4,6 c) d) ans: a

49) The line current will be equal to phase current in______ ans: delta connection

50) In windmills the frequent problems occur in______ a) mechanical system b) blades c) electrodynamic system d) electric system

51) The machine used in windmills is______ a) alternator b) induction generator c) d) ans: b

52) Insulators in EHV lines are designed based on_____ a) switching voltages b) peak voltages c) corona d) lightning voltages ans: a 53) The value of restriking voltage depends on______ a) inductance of line b) capacitance of line c) both d) none
Reply With Quote Quick reply to this message
Reply

Similar Threads
Thread Thread Starter Forum Replies Last Post
MHT MBA CET previous year papers payal Online MBA Discussions 2 9th April 2018 10:22 AM
GAIL Papers Electrical Shirsendu Paul.r Main Forum 2 4th April 2018 09:58 PM
EIL Previous Papers Electronics Soniya Patel hl, Main Forum 2 28th March 2018 12:39 PM
IPU CET MBA Previous Papers mamta Online MBA Discussions 2 21st March 2018 11:40 AM
AIMCET Previous Papers Unregistered Main Forum 2 17th March 2018 02:31 PM
LIC ADO Previous Year Papers Unregistered Main Forum 1 7th November 2016 06:15 PM
ISRO Question Papers For Electrical Engineering Unregistered Main Forum 1 7th November 2016 03:44 PM
HAL MT Previous Papers For EEE Unregistered Main Forum 1 25th October 2016 12:05 PM
NTPC Electrical previous year placement papers Unregistered Online MBA Discussions 1 19th November 2015 11:32 AM
AUEET Previous Papers Unregistered Main Forum 0 17th July 2015 08:54 AM
Previous Papers of SSC CPO SI Unregistered Main Forum 0 14th July 2015 01:41 PM
CG PET previous papers Unregistered Main Forum 0 13th July 2015 04:58 PM
BARC Previous Question Papers For Electronics BARC Previous Papers Unregistered Main Forum 0 9th July 2015 09:50 AM
APGENCO Question Papers For Electrical ahmed abdul sattar.p Main Forum 2 9th February 2015 02:52 AM
HPCL Electrical Engineering Previous Year Papers Unregistered Main Forum 1 13th October 2014 04:38 PM
SSC CGL Previous Papers srinath.p1543 Main Forum 1 29th January 2013 11:51 AM
EAMCET Previous Papers Papers snehaa Main Forum 1 23rd January 2013 04:44 PM
ECIL model papers electrical sujata mana Main Forum 1 23rd January 2013 11:01 AM
GAIL Previous Papers For Electrical Mrs. Pritee Chak Main Forum 1 30th November 2012 05:06 PM
APPSC Previous Papers AEE Electrical technical training Main Forum 1 12th July 2012 05:36 PM


Quick Reply
Your Username: Click here to log in

Message:
Options

Thread Tools Search this Thread



All times are GMT +5.5. The time now is 10:11 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Friendly URLs by vBSEO 3.6.0 PL2

1 2