#1
| |||
| |||
SSC Junior Engineer Civil Solved Paper |
#3
| |||
| |||
Re: SSC Junior Engineer Civil Solved Paper
As you Asking for the Question Paper of the Staff Selection Commission Junior Engineer Recruitment Civil Engineering the Question Paper is given below The crushing strength (MPa) of good stone used for construction of a building must not be less than ____. Options: 1) 10 2) 50 3) 100 4) 120 Correct Answer: 100 In ordinary cement, about 99% of its final strength is achieved in _____. Options: 1) 3 days 2) 7 days 3) 28 days 4) 1 year Correct Answer: 28 days - In the process of the hydration of OPC, what is the water requirement (expressed as the percentage by weight of cement) to complete the chemical reactions? Options: 1) 15 to 25% 2) 20 to 25% 3) 25 to 35% 4) 35 to 45% Correct Answer: 20 to 25% What is the main reason to use lime in the cement slurry during the plastering in the top coat? Options: 1) To make the surface bright. 2) To harden the cement. 3) To make the plaster non-shrinkable. 4) To improve the workability of plaster. Correct Answer: To make the plaster non-shrinkable. Bulking of sand occurs in the moisture content of _____. Options: 1) 3% 2) 5% 3) 10% 4) 12% Correct Answer: 5% Which of the following is the main advantage of the plywood? Options: 1) Strength is more in the longitudinal direction. 2) Strength is more in the transverse direction. 3) Tensile strength is same in all directions. 4) Shrinkage stress is minimum. Correct Answer: Tensile strength is same in all directions. The hardwood is produced by which of the following trees? Options: 1) Chir 2) Kail 3) Pine 4) Shishum Correct Answer: Shishum Which one of the following metamorphic rocks has more weathering resistance characteristics? Options: 1) Lime stone 2) Phyllite 3) Quartzite 4) Slate Correct Answer: Quartzite Which of the following type of stone is used in the rubble masonry? Options: 1) Hard 2) Heavy weighted 3) Light weighted 4) Smooth Correct Answer: Hard The hydraulicity of the hydraulic lime is mainly due to _____. Options: 1) calcium oxide 2) clay 3) sulphur 4) water Correct Answer: clay What percentage of the cost of the estimate is provided for the work charged establishment? Options: 1) 2% 2) 8% 3) 10% 4) 15% Correct Answer: 2% What is the thickness (inches) of the one brick wall made up of traditional brick? Options: 1) 9 2) 10 3) 18 4) 20 Correct Answer: 9 Which one is the CORRECT option for the damp proof course? Options: 1) It is measured in the cubic meter. 2) It is measured in running meter. 3) It is not provided at sills of doors. 4) It is provided for half the width of the plinth wall. Correct Answer: It is not provided at sills of doors. Calculate the years purchase for a property of useful life of 30 years and rate of interest of 5% per annum. Options: 1) 0.05 2) 0.2 3) 2 4) 20 Correct Answer: 20 What is the density of the mild steel in quintal per cubic meter? Options: 1) 7.85 2) 78.5 3) 490 4) 7850 Correct Answer: 78.5 Cleaning and fixing of glass panel is measured in _____. Options: 1) cubic meter 2) meter 3) number 4) square meter Correct Answer: number Calculate the volume (cubic meter) of earthwork for an embankment of length 30 m and width 4 m. The mean depth of the embankment is 4 m and side slope is 2 : 1. Using mid-sectional area method. Options: 1) 480 2) 960 3) 1440 4) 1920 Correct Answer: 1440 Calculate the quantity (cubic meter) of the cement required for 1 cubic meter of brick work with cement mortar (1 : 4). Options: 1) 0.05 2) 0.06 3) 0.2 4) 0.24 Correct Answer: 0.06 Which one is the CORRECT statement for conversion of the lift into lead? Options: 1) Lift up to 3.6 m is converted into the horizontal lead by multiplying with 10. 2) Lift up to 3.6 m is converted into horizontal lead by multiplying with 15 3) Lift up to 3.6 m is converted into horizontal lead by multiplying with 20 4) Lift above 6 m is converted into horizontal lead by multiplying with 10 Correct Answer: Lift up to 3.6 m is converted into the horizontal lead by multiplying with 10. A building has been purchased by a person at a cost of Rs. 25,000. The useful life of the building is 40 years and the scrap value of the building is Rs. 3,000. Calculate the annual sinking fund (Rs.) at the rate of 5% interest. Options: 1) 136 2) 155 3) 182 4) 207 Correct Answer: 182 - Plumb bob lines at two different places in geodetic surveying will _____. Options: 1) intersect at the surface of the Earth 2) intersect at the center of the Earth 3) parallel to each other 4) perpendicular to each other Correct Answer: intersect at the center of the Earth Calculate the true reduced level (m) of a point A after correcting the refraction and curvature. The staff reading at the point taken from an instrument set at a distance of 2 km from the point A is 2.56 m. The staff reading from the same station on a bench mark of reduced level is 100 m is 1.34 m. Options: 1) 98.51 2) 99.78 3) 99.05 4) 101.3 Correct Answer: 99.05 Which one is the CORRECT expression for the horizontal distance between the instrument and the staff for the anallactic telescope, if S is the staff intercept, K and C are multiplying and additive constant? Options: 1) C 2) 100C 3) S 4) 100S Correct Answer: 100S With an increase in the denominator of the representative fraction, the scale of the map will _____. Options: 1) decrease 2) either decrease or increase 3) increase 4) remain same Correct Answer: decrease - Calculate the length of one division of the vernier scale, if least count of the combination of main and vernier scale is 0.02 mm. The least count of the main scale is 1 mm. Options: 1) 1 2) 0.98 3) 1.02 4) 1.03 Correct Answer: 0.98 - Which one is the CORRECT statement? Options: 1) Length of engineering chain is 33 ft. 2) Length of engineering chain is 66 ft. 3) Length of Gunters chain is 66 ft. 4) Length of revenue chain is 33 ft. Correct Answer: Length of Gunters chain is 66 ft. Which of the following statement is CORRECT for whole circle bearing? Options: 1) It is always measured in anticlockwise direction. 2) It is always measured in anticlockwise direction from south end of the reference. 3) It is always measured in clockwise direction from south end of the reference. 4) It is always measured from north end of the reference. Correct Answer: It is always measured from north end of the reference. - Calculate the length (m) tangent of a 5 degree curve, if the deflection angle is 60 degree. Options: 1) 172.5 2) 198.6 3) 360 4) 596 Correct Answer: 198.6 - Calculate the limiting length (m) of the offset, if the maximum allowable error in laying offset is 2 degree. The scale of the map is 1 cm = 100 m. Options: 1) 2.5 2) 71.63 3) 250 4) 2865 Correct Answer: 71.63 - Calculate the error in the staff reading on a staff at a distance of 100 m due to out of the center of the bubble by 4 divisions. The sensitivity of the bubble tube is 30 seconds per 2 mm divisions Options: 1) 0.29 2) 0.34 3) 0.58 4) 0.67 Correct Answer: 0.58 |
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
SSC Junior Engineer Website | Unregistered | Main Forum | 2 | 16th April 2018 08:46 AM |
SSC Junior Engineer Result | RISHI.d | Main Forum | 2 | 22nd March 2018 10:27 AM |
DMRC Junior Engineer Notification | Unregistered | Main Forum | 1 | 1st November 2016 04:23 PM |
Junior Engineer Civil Vacancy In UPPSC | Unregistered | Main Forum | 1 | 20th October 2016 04:29 PM |
UPPSC Junior Engineer Civil Result | Unregistered | Main Forum | 0 | 17th July 2015 04:12 PM |
Model question paper for SSC junior engineer electrical | Unregistered | Main Forum | 0 | 16th July 2015 05:48 PM |
Qualification for SSC Junior Engineer | Unregistered | Main Forum | 0 | 16th July 2015 05:32 PM |
SSC Junior Engineer Model Paper | Unregistered | Main Forum | 0 | 16th July 2015 01:45 PM |
Recruitment of Junior Engineer by SSC | Unregistered | Main Forum | 0 | 16th July 2015 10:28 AM |
SSC Junior engineer previous year question paper | Unregistered | Main Forum | 0 | 15th July 2015 05:34 PM |
Junior Engineer DSSSB | Unregistered | Main Forum | 0 | 15th July 2015 08:50 AM |
SSC Junior Engineer Interview Letter | Unregistered | Main Forum | 0 | 14th July 2015 01:21 PM |
SSC junior engineer recruitment | Unregistered | Main Forum | 0 | 13th July 2015 04:52 PM |
SSC junior engineer civil syllabus pdf | Unregistered | Main Forum | 0 | 13th July 2015 04:40 PM |
SSC NR Junior Engineer Admit Card | Unregistered | Main Forum | 0 | 13th July 2015 11:00 AM |
SSC junior engineer result 25 may | Unregistered | Main Forum | 0 | 10th July 2015 03:49 PM |
SSC junior engineer recruitment | nhybs | Main Forum | 1 | 17th January 2013 05:00 PM |
SSC Junior Engineer Exam Syllabus | kezarava.xx | Main Forum | 1 | 19th October 2012 10:15 AM |
SSC Junior Engineer Eligibility | soumya44 | Main Forum | 1 | 14th September 2012 12:19 PM |
SSC Junior Engineer Civil & Electrical Result | Gtank | Main Forum | 1 | 27th June 2012 05:05 PM |
Thread Tools | Search this Thread |
|