Go Back   2023 2024 MBA > MBA > Main Forum

  #1  
Old 15th October 2016, 11:42 AM
Unregistered
Guest
 
Default HPCL Previous Question Papers For ECE

I want the question paper of Electronics & Communication Engg. (ECE) of HPCL exam so can you provide me?
Reply With Quote Quick reply to this message
  #2  
Old 15th October 2016, 12:00 PM
Super Moderator
 
Join Date: Mar 2013
Default Re: HPCL Previous Question Papers For ECE

As you are looking for the question paper of Electronics & Communication Engg (ECE) of HPCL exam so here I am providing you.

HPCL exam ECE question paper

1. Removing bypass capacitor across the emitter-leg resistor in a CE amplifier causes

(A) increase in current gain.
(B) decrease in current gain.
(C) increase in voltage gain.
(D)decrease in voltage gain.
Ans: D



2. When a step-input is given to an op-amp integrator, the output will be

(A) a ramp.
(B) a sinusoidal wave.
(C) a rectangular wave.
(D) a triangular wave with dc bias.
Ans: A



3. Hysteresis is desirable in Schmitt-trigger, because

(A) energy is to be stored/discharged in parasitic capacitances.
(B) effects of temperature would be compensated.
(C) devices in the circuit should be allowed time for saturation and desaturation.
(D) it would prevent noise from causing false triggering.
Ans: C



4. Space charge region around a p-n junction

(A) does not contain mobile carriers
(B) contains both free electrons and holes
(C) contains one type of mobile carriers depending on the level of doping of the p or n regions
(D) contains electrons only as free carriers
Ans: A



5. When an amplifier is provided with current series feedback, its

(A) input impedance increases and output impedance decreases
(B) input and output impedances both decrease
(C) input impedance decreases and output impedance increases
(D) input and output impedances both increase
Ans: D



6. The fan-out of a MOS-logic gate is higher than that of TTL gates because of its

(A) low input impedance
(B) high output impedance
(C) low output impedance
(D) high input impedance

Ans: D



7. A highly stable resonance characteristic is the property of a ____ oscillator.

(A) Hartley
(B) Colpitts
(C) Crystal
(D) Weinbridge
Ans. (C)



8. A phase shift oscillator uses __________________.

(A) LC tuning
(B) Piezoelectric crystal
(C) Balanced bridge
(D) Variable frequency operation
Ans. (C)



9. A bistable multivibrator is a

(A) Free running oscillator.
(B) Triggered oscillator.
(C) Saw tooth wave generator.
(D) Crystal oscillator
Ans:B



10. The number of point to point links required in a fully connected network for 50 entities is

(A) 1250
(B) 1225
(C) 2500
(D) 50
Ans: (C)



11. The ________is a circuit-switched network, while the ______is a packet-switched network.

(A) Telephone, ATM
(B) SONET and FDDI
(C) Satellite, Telephone
(D) FDDI and SONET
Ans: (A)



12. Direct inward dialling is used as a feature in

(A) PSTN.
(B) PBX.
(C) EPABX.
(D) VPN.
Ans: (C)



13. ISDN handles data pertaining to

(A) All digital services
(B) Speech and Video
(C) Computer data only
(D) Speech only
Ans: (A)



14. A BJT operates as a switch

(A)under small signal conditions
(B)with no signal condition
(C)in the active region of transfer characteristic
(D)under large signal conditions
Ans



15. Bulk power transmission over long HVDC lines are preferred, on account of

(A)low cost of HVDC terminals
(B)no harmonic problems
(C)minimum line power losses
(D)simple protection

Ans:C



16. A converter which can operate in both 3-pulse and 6-pulse modes is

(A)1-phase full converter
(B)3-phase half wave converter
(C)3-phase semiconverter
(D)3-phase full converter
Ans:C



17. A three-phase semiconverter feeds the armature of a separately excited dcmotor, supplying a nonzero torque. For steady-state operation, the motor armature current is found to drop to zero at certain instances of time. At suchinstances, a voltage assumes a value that is

(A)equal to the instantaneous value of the ac phase voltage
(B)equal to the instantaneous value of the motor back emf
(C)arbitrary
(D)zero

Ans:B



18. The frequency of the ripple in the output voltage of a 3-phase semiconverter depends upon

(A)firing angle and load resistance
(B)firing angle and supply frequency
(C)firing angle and load inductance
(D)only on load circuit parameters
Ans:B



19. In dielectric heating, the rate of heating cannot be increased by increasing the potential gradient because

(A)Coupling problems become highly pronounced
(B)Very high voltages are not easily available
(C)Heating becomes non-uniform
(D)Corona takes place
Ans



20. The speed and torque of induction motors can be varied by which of thefollowing means?

(A)Stator voltage control
(B)Rotor voltage control
(C)Frequency control
(D)All of these

Ans
Reply With Quote Quick reply to this message
Reply

Similar Threads
Thread Thread Starter Forum Replies Last Post
MBA 2nd Sem Previous Question Papers payal Online MBA Discussions 2 28th March 2018 09:19 AM
PGCET Previous Question Papers For MBA payal Online MBA Discussions 2 27th March 2018 05:26 PM
SBI PO Previous Question Papers Unregistered Main Forum 1 21st April 2017 02:09 PM
HPCL Previous Year Question Papers For Electronics Unregistered Main Forum 1 19th November 2016 11:11 AM
BVP CET Previous Year Question Papers Unregistered Main Forum 1 10th November 2016 11:46 AM
HPCL Previous Question Papers For EEE Unregistered Main Forum 1 9th November 2016 06:02 PM
Previous Question Papers Of PGCET Unregistered Main Forum 1 7th November 2016 09:58 AM
OPSC Previous Question Papers Unregistered Main Forum 1 2nd November 2016 04:50 PM
HAL MT Previous Year Question Papers For ECE Unregistered Main Forum 1 2nd November 2016 04:15 PM
Previous TANCET Question Papers Unregistered Main Forum 1 19th October 2016 05:46 PM
Previous Question Papers of B.Ed of CCS University Unregistered Main Forum 1 19th October 2016 05:03 PM
JL Mathematics Previous Question Papers Unregistered Main Forum 1 27th September 2016 03:38 PM
Dr MGR university previous question papers Unregistered Main Forum 0 20th July 2015 09:20 AM
BARC Previous Question Papers For Electronics BARC Previous Papers Unregistered Main Forum 0 9th July 2015 09:50 AM
NIPER Previous Question Papers Unregistered Main Forum 1 21st October 2014 09:36 AM
CIL Previous Question Papers Unregistered Main Forum 1 20th October 2014 10:03 AM
HPCL Electrical Engineering Previous Year Papers Unregistered Main Forum 1 13th October 2014 04:38 PM
ICAR.NET Previous question papers Unregistered Main Forum 1 12th October 2014 02:40 PM
IGNOU previous question papers MEG vamshiasvampire Main Forum 2 2nd June 2014 10:13 AM
Previous IIT JEE question papers with solutions ravigusain Main Forum 1 8th February 2013 09:57 AM


Quick Reply
Your Username: Click here to log in

Message:
Options

Thread Tools Search this Thread



All times are GMT +5.5. The time now is 08:46 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Friendly URLs by vBSEO 3.6.0 PL2

1 2