| 1st October 2016 04:58 PM | |
| shikha | Re: VTU PSOC Question Papers I will get the VTU, BE Power System Operation And Control exam paper and syllabus so that you can check it easily. BE Power System Operation And Control, VTU exam paper   Here is the syllabus Unit-1 CONTROL CENTER OPERATION OF POWER SYSTEMS 8 hours Power system control and operating states, control center, digital computer configuration, automatic generation control, area control error, operation without central computers, expression for tie-line flow and frequency deviation, parallel operation of generators, area lumped dynamic model. Unit-2 & 3 AUTOMATIC VOLTAGE REGULATOR AUTOMATIC LOAD FREQUENCY CONTROL 12 hours AUTOMATIC VOLTAGE REGULATOR: Basic generator control loops, Cross-coupling between control loops, Exciter types, Exciter modeling, Generator modeling, Static performance of AVR loop. AUTOMATIC LOAD FREQUENCY CONTROL:Automatic Load frequency control of single area systems, Speed governing system, Hydraulic valve actuator, Turbine generator response, Static performance of speed governor, Closing of ALFC loop, Concept of control area, Static response of primary ALFC loop, Integral control, ALFC of multi-control area systems (POOL operation),The Two-Area system, Modeling the Tie-Line, Block Diagram representation of Two-Area system, Static response of Two-Area system and Tie-Line Bias control. Unit-4 CONTROL OF VOLTAGE AND REACTIVE POWER 6 hours Introduction, generation and absorption of reactive power, relation between voltage, power and reactive power at a node, single machine infinite bus systems, methods of voltage control, sub synchronous resonance, voltage stability, voltage collapse. Part B Unit-5 OPTIMAL SYSTEM OPERATION AND UNIT COMMITMENT 6 hours Introduction , Optimal operation of generators on a bus bar, Statement of the Unit Commitment problem, need and importance of unit commitment, Constraint in Unit Commitment, Unit Commitment solution methods-Priority lists method, Forward Dynamic Programming method( excluding problem), Spinning reserve. Unit-6 POWER SYSTEM SECURITY 6 hours Introduction, factors affecting power system security, Security analysis, Contingency Selection, Techniques for contingency evaluation-D.C. load flow and fast decoupled load flow. Unit-7 SYSTEM MONITORING AND CONTROL 6 hours Introduction , Energy management system, the basis of power system state estimation(PSSE), mathematical description of PSSE process, minimization technique for PSSE, Least Square estimation, Error and detection in PSSE, System security and emergency control. Unit-8 POWER SYSTEM RELIABILITY 8 hours Introduction, Modes of failures of a system, Generating system and its performance, derivation of reliability index, reliability measure for N- unit system, cumulative probability outages- Recursive Relation, Loss of load probability, Frequency and duration of a state. |
| 1st October 2016 03:18 PM | |
| Unregistered | VTU PSOC Question Papers Someone of you please get the BE Power System Operation And Control, VTU exam paper and syllabus so that I can check it? |
