11th March 2013 04:20 PM | |
Arvind Kumar | Re: GATE Old Question Papers With Solutions For Mechanical You want GATE Mechanical Engineering question paper so I have it and I am sharing it with you: Q.1 In abrasive jet machining, as the distance between the nozzle tip and the work surface increases, the material removal rate (A) increases continuously. (B) decreases continuously. (C) decreases, becomes stable and then increases. (D) increases, becomes stable and then decreases. Q.2 Match the following metal forming processes with their associated stresses in the workpiece. Metal forming process Type of stress 1. Coining P. Tensile 2. Wire Drawing Q. Shear 3. Blanking R. Tensile and compressive 4. Deep Drawing S. Compressive (A) 1-S, 2-P, 3-Q, 4-R (B) 1-S, 2-P, 3-R, 4-Q (C) 1-P, 2-Q, 3-S, 4-R (D) 1-P, 2-R, 3-Q, 4-S Q.3 In an interchangeable assembly, shafts of size 010 . 0 040 . 0 000 . 25 mm mate with holes of size 020 . 0 030 . 0 000 . 25 mm. The maximum interference (in microns) in the assembly is (A) 40 (B) 30 (C) 20 (D) 10 Q.4 During normalizing process of steel, the specimen is heated (A) between the upper and lower critical temperature and cooled in still air. (B) above the upper critical temperature and cooled in furnace. (C) above the upper critical temperature and cooled in still air. (D) between the upper and lower critical temperature and cooled in furnace. Q.5 Oil flows through a 200 mm diameter horizontal cast iron pipe (friction factor, f = 0.0225) of length 500 m. The volumetric flow rate is 0.2 m3/s. The head loss (in m) due to friction is (assume g = 9.81 m/s2) (A) 116.18 (B) 0.116 (C) 18.22 (D) 232.36 Complete question paper is given in attached pdf file. this file is free for you. GATE Mechanical Question Paper |
11th March 2013 10:19 AM | |
majadhhar | GATE Old Question Papers With Solutions For Mechanical From where can I get GATE Mechanical Engineering question paper? |