2nd April 2018 11:23 AM | |
shikha | Re: SSC Junior Engineer Civil Solved Paper As you Asking for the Question Paper of the Staff Selection Commission Junior Engineer Recruitment Civil Engineering the Question Paper is given below The crushing strength (MPa) of good stone used for construction of a building must not be less than ____. Options: 1) 10 2) 50 3) 100 4) 120 Correct Answer: 100 In ordinary cement, about 99% of its final strength is achieved in _____. Options: 1) 3 days 2) 7 days 3) 28 days 4) 1 year Correct Answer: 28 days - In the process of the hydration of OPC, what is the water requirement (expressed as the percentage by weight of cement) to complete the chemical reactions? Options: 1) 15 to 25% 2) 20 to 25% 3) 25 to 35% 4) 35 to 45% Correct Answer: 20 to 25% What is the main reason to use lime in the cement slurry during the plastering in the top coat? Options: 1) To make the surface bright. 2) To harden the cement. 3) To make the plaster non-shrinkable. 4) To improve the workability of plaster. Correct Answer: To make the plaster non-shrinkable. Bulking of sand occurs in the moisture content of _____. Options: 1) 3% 2) 5% 3) 10% 4) 12% Correct Answer: 5% Which of the following is the main advantage of the plywood? Options: 1) Strength is more in the longitudinal direction. 2) Strength is more in the transverse direction. 3) Tensile strength is same in all directions. 4) Shrinkage stress is minimum. Correct Answer: Tensile strength is same in all directions. The hardwood is produced by which of the following trees? Options: 1) Chir 2) Kail 3) Pine 4) Shishum Correct Answer: Shishum Which one of the following metamorphic rocks has more weathering resistance characteristics? Options: 1) Lime stone 2) Phyllite 3) Quartzite 4) Slate Correct Answer: Quartzite Which of the following type of stone is used in the rubble masonry? Options: 1) Hard 2) Heavy weighted 3) Light weighted 4) Smooth Correct Answer: Hard The hydraulicity of the hydraulic lime is mainly due to _____. Options: 1) calcium oxide 2) clay 3) sulphur 4) water Correct Answer: clay What percentage of the cost of the estimate is provided for the work charged establishment? Options: 1) 2% 2) 8% 3) 10% 4) 15% Correct Answer: 2% What is the thickness (inches) of the one brick wall made up of traditional brick? Options: 1) 9 2) 10 3) 18 4) 20 Correct Answer: 9 Which one is the CORRECT option for the damp proof course? Options: 1) It is measured in the cubic meter. 2) It is measured in running meter. 3) It is not provided at sills of doors. 4) It is provided for half the width of the plinth wall. Correct Answer: It is not provided at sills of doors. Calculate the years purchase for a property of useful life of 30 years and rate of interest of 5% per annum. Options: 1) 0.05 2) 0.2 3) 2 4) 20 Correct Answer: 20 What is the density of the mild steel in quintal per cubic meter? Options: 1) 7.85 2) 78.5 3) 490 4) 7850 Correct Answer: 78.5 Cleaning and fixing of glass panel is measured in _____. Options: 1) cubic meter 2) meter 3) number 4) square meter Correct Answer: number Calculate the volume (cubic meter) of earthwork for an embankment of length 30 m and width 4 m. The mean depth of the embankment is 4 m and side slope is 2 : 1. Using mid-sectional area method. Options: 1) 480 2) 960 3) 1440 4) 1920 Correct Answer: 1440 Calculate the quantity (cubic meter) of the cement required for 1 cubic meter of brick work with cement mortar (1 : 4). Options: 1) 0.05 2) 0.06 3) 0.2 4) 0.24 Correct Answer: 0.06 Which one is the CORRECT statement for conversion of the lift into lead? Options: 1) Lift up to 3.6 m is converted into the horizontal lead by multiplying with 10. 2) Lift up to 3.6 m is converted into horizontal lead by multiplying with 15 3) Lift up to 3.6 m is converted into horizontal lead by multiplying with 20 4) Lift above 6 m is converted into horizontal lead by multiplying with 10 Correct Answer: Lift up to 3.6 m is converted into the horizontal lead by multiplying with 10. A building has been purchased by a person at a cost of Rs. 25,000. The useful life of the building is 40 years and the scrap value of the building is Rs. 3,000. Calculate the annual sinking fund (Rs.) at the rate of 5% interest. Options: 1) 136 2) 155 3) 182 4) 207 Correct Answer: 182 - Plumb bob lines at two different places in geodetic surveying will _____. Options: 1) intersect at the surface of the Earth 2) intersect at the center of the Earth 3) parallel to each other 4) perpendicular to each other Correct Answer: intersect at the center of the Earth Calculate the true reduced level (m) of a point A after correcting the refraction and curvature. The staff reading at the point taken from an instrument set at a distance of 2 km from the point A is 2.56 m. The staff reading from the same station on a bench mark of reduced level is 100 m is 1.34 m. Options: 1) 98.51 2) 99.78 3) 99.05 4) 101.3 Correct Answer: 99.05 Which one is the CORRECT expression for the horizontal distance between the instrument and the staff for the anallactic telescope, if S is the staff intercept, K and C are multiplying and additive constant? Options: 1) C 2) 100C 3) S 4) 100S Correct Answer: 100S With an increase in the denominator of the representative fraction, the scale of the map will _____. Options: 1) decrease 2) either decrease or increase 3) increase 4) remain same Correct Answer: decrease - Calculate the length of one division of the vernier scale, if least count of the combination of main and vernier scale is 0.02 mm. The least count of the main scale is 1 mm. Options: 1) 1 2) 0.98 3) 1.02 4) 1.03 Correct Answer: 0.98 - Which one is the CORRECT statement? Options: 1) Length of engineering chain is 33 ft. 2) Length of engineering chain is 66 ft. 3) Length of Gunters chain is 66 ft. 4) Length of revenue chain is 33 ft. Correct Answer: Length of Gunters chain is 66 ft. Which of the following statement is CORRECT for whole circle bearing? Options: 1) It is always measured in anticlockwise direction. 2) It is always measured in anticlockwise direction from south end of the reference. 3) It is always measured in clockwise direction from south end of the reference. 4) It is always measured from north end of the reference. Correct Answer: It is always measured from north end of the reference. - Calculate the length (m) tangent of a 5 degree curve, if the deflection angle is 60 degree. Options: 1) 172.5 2) 198.6 3) 360 4) 596 Correct Answer: 198.6 - Calculate the limiting length (m) of the offset, if the maximum allowable error in laying offset is 2 degree. The scale of the map is 1 cm = 100 m. Options: 1) 2.5 2) 71.63 3) 250 4) 2865 Correct Answer: 71.63 - Calculate the error in the staff reading on a staff at a distance of 100 m due to out of the center of the bubble by 4 divisions. The sensitivity of the bubble tube is 30 seconds per 2 mm divisions Options: 1) 0.29 2) 0.34 3) 0.58 4) 0.67 Correct Answer: 0.58 |
2nd April 2018 11:22 AM | |
Unregistered | Re: SSC Junior Engineer Civil Solved Paper Hii sir, I Wants to get the Question Paper of the Staff Selection Commission Junior Engineer Recruitment Civil Engineering Question Paper ? |
8th July 2015 12:51 PM | |
Unregistered | SSC Junior Engineer Civil Solved Paper From where I can download question papers for SSC Junior Engineer (Civil) Examination? I am doing preparation for this Exam by its syllabus and books. Recently I have completed its syllabus. So please provide me solved question papers of SSC Junior Engineer (Civil) Exam. |